Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateGarage Door Company in Ontario, CA
Garage door installation in Ontario, CA is shaped by one thing more than any other: the city’s enormous stock of 1950s – 1970s tract homes. We replace and retrofit more original single-car wood doors and thin-gauge steel panels here than almost anywhere else in the Inland Empire. The heat doesn’t help either – Ontario summers routinely pass 100°F, which warps aging panels and cooks lubricants out of rollers and hinges. If you need a new door, a spring retrofit, or an opener that can handle daily use, call (866) 282-7068 and we’ll give you a straight answer.
Why Ontario Homes Are Different
Walk the older tracts off Holt Boulevard or Euclid Avenue and you’ll see the same story repeated: attached one- and two-car garages built between 1955 and 1975, many with the original door still hanging. In ZIPs 91761, 91762, and 91764, those doors are often narrow single-car units with wood panels that have rotted along the bottom from decades of lawn irrigation overspray. The spring can be fine while the door itself is failing – a pattern we rarely see in newer subdivisions to the west.
Ontario’s climate compounds the problem. Dry Santa Ana winds pull moisture from wood, leaving panels brittle and prone to cracking along the stiles. Summer heat cycles stress torsion springs faster than coastal air ever would. And when winter rains arrive, rotted bottom seals let water sit against the track, which rusts and binds. Any door we install or repair in Ontario has to be spec’d for this inland heat and wind reality – not just ordered out of a catalog.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Our Main Ontario Services
Most Ontario homeowners call us for one of two reasons: a garage door that won’t open, or an opener that stopped responding. Both are covered below, and each has its own dedicated Ontario page.
Garage Door Repair in Ontario
When a torsion spring snaps in a 1960s Ontario tract home, it usually happens at the worst possible moment – early morning, car still inside, kids waiting for a ride. We carry springs, cables, rollers, and hinge sets sized for the narrow single-car doors common in 91761, 91762, and 91764. Older wood doors need heavier reinforcement plates and careful balance work, which is exactly where we spend most of our repair time here. Read more on the Garage Door Repair in Ontario page, or call (866) 282-7068.
Garage Door Opener Repair in Ontario
Opener failures in Ontario split into two camps: old chain-drive units from the 1990s that have finally stripped a gear, and newer smart openers with WiFi boards that won’t pair. We diagnose both sides – the opener and the door it’s trying to lift – because a tired spring can make a healthy opener look dead. If your myQ or Aladdin Connect app stopped working, we’ll tell you whether the board or the travel limits are the real culprit. Full details live on the Garage Door Opener Repair in Ontario page.
Garage Door Installation in Ontario
Most original garage doors in Ontario’s mid-century tracts have outlived their useful life by two decades. The wood panels were never built for 100°F summers and Santa Ana wind, and the hardware has been through more cycles than it was ever rated for. A new door here should be steel or insulated composite – not wood – sized correctly for the narrow headers common in 91761 and 91764. For a full walkthrough of the process, see our Garage Door Installation hub.
Garage Door Replacement
Signs you need it
Rotted bottom sections, visible daylight through panel seams, or a door that’s been patched with brackets and plywood are all Ontario-specific signals that replacement costs less than another repair.
What it costs in Ontario
A full garage door replacement in Ontario typically runs $700 – $2,200 depending on door size, insulation level, and hardware included.
How we do it
We measure the rough opening, pull the old door and track, install new horizontal and vertical track with fresh hardware, hang the new panels, set spring tension, and test balance through a full cycle.
Garage Door Installation Service
Signs you need it
New home construction, a garage conversion, or a door that’s already been condemned by a home inspector all require full installation rather than a patch job.
What it costs in Ontario
Complete installation with new tracks, springs, rollers, and a standard steel door ranges from $700 – $2,200 in Ontario.
How we do it
We confirm header condition and side clearances, install track and panels, attach springs and cables, set the opener if included, and finish with a seal test along the bottom and sides.
What Garage Door Installation Costs in Ontario
| Item | Typical range in Ontario |
|---|---|
| New steel door, single-car | $700 – $1,500 |
| New door, double-car with insulation | $1,200 – $2,200 |
| Panel replacement (per panel) | $250 – $500 |
The price you’re quoted is the price you pay – we confirm numbers before any work starts, and there’s no surprise add-on when the job is done.
Can you install a door on an older Ontario home with a narrow single-car opening?
Yes. We regularly install doors on the narrow single-car openings common in 1960s tract homes, using doors sized to the existing header and side clearances. Call (866) 282-7068 and we’ll measure the opening and give you a written quote.
How long does garage door installation take in Ontario?
Most residential installations are done in one day, usually four to six hours including removal of the old door and hardware. Commercial jobs take longer depending on door size and opener complexity. Call (866) 282-7068 for a time estimate on your specific setup.
Brands We Service in Ontario
We work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor – so almost no job in Ontario requires a brand-specific call. Our trucks carry common parts for all eight brands, and for less common parts we can usually source same-week from regional suppliers. See our brands for full coverage details.
See the difference
Before
After
Before
After
Before
AfterPricing for Garage Door Company in Ontario, CA
| Service | Typical range in Ontario |
|---|---|
| Spring repair | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2,200 |
| Garage door repair | $150 – $600 |
Two things push prices upward in Ontario: doors that are original to 1950s – 1970s tract homes often need header or track retrofit work, and summer heat fatigue means springs and rollers are usually replaced together rather than one at a time. Whatever the number, we quote it before we touch a wrench – no open-ended invoices, no day-of surprises.
Neighborhoods We Serve in Ontario
We cover every ZIP in Ontario – 91758, 91761, 91762, and 91764 – and most neighborhoods fall within a short drive for us. Here are a few areas we work in regularly:
- North Ontario – including the older tracts along Holt Boulevard
- Downtown Ontario – Euclid Avenue corridor and surrounding mid-century blocks
- South Ontario – neighborhoods south of Mission Boulevard
- Cypress – newer developments near the 15 freeway
- West Ontario – subdivisions bordering Montclair
For repair calls, we’re typically able to reach most Ontario addresses within 60 – 90 minutes.
Service Area – Cities Near Ontario
Beyond Ontario, we serve homeowners throughout the western Inland Empire. That includes Montclair, CA just to the west, Upland, CA to the north, Chino, CA to the south, and Rancho Cucamonga, CA further east. If you’re in one of these cities and need garage door work, call (866) 282-7068 and we’ll confirm the next available appointment.
Serving Ontario, CA – Our Local Coverage Area
We’re based in the Ontario area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Garage Door Company in Ontario
For most repair calls in Ontario, we arrive within 60 – 90 minutes. Installation and replacement appointments are scheduled in advance since they require measuring, ordering, and a full day or half day of work. Call (866) 282-7068 and we’ll give you a real window, not a vague promise.
Some Ontario HOAs – particularly in newer subdivisions – require design review before a door replacement, mostly around color and panel style. Permits are generally not required for swapping an existing door on a single-family home, but we can confirm what applies to your address. If your HOA has rules, we’ll help you pull together what they need.
Yes, and we do it all the time. Original wood doors from that era often need panel reinforcement or full replacement, but the surrounding structure is usually sound. We’ll tell you honestly whether repair makes sense or whether a new door is the better long-term spend, with the numbers to back it up.
If your garage door is down and you need it moving again, or you’re ready to replace a door that’s been running since the Nixon administration, call (866) 282-7068. We’ll get you a free estimate, an honest read on your hardware, and a price that’s set before we start. Garage Door Service Pomona has served Ontario since 2016.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local garage door pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically within the hour.
- 4You approve before work beginsNothing starts until you say go.
What Ontario Customers Say
"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Beatriz Delgado"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Oscar Castillo"Track was bent and two of the rollers were shot. He straightened what he could, swapped the rollers for nylon ones, lubricated everything, and had it done in about an hour."
- Michelle Park